Right rear hub bearing making excessive noise. Tech notated that brake vibration is felt from front and rear with rear being slightly worse. Pad life is at 50%. Would need front and rear brake job to correct vibration. Check engine light on for numerous codes= P0420=Catalyst Bank1, P2407= EVAP Leak, P0575=Cruise, U0405 =Cruise Module, C0094= Steering Angle Sensor, 6F01, 8B01, 8A20=Light Fault Codes.
Found RR tail light not working, LF driver side low beam inop due to missing bulb and other parts, customer has part and will take care of light bulb on their own. All rotors are warped=would need a complete brake job to remedy.
Replaced Right Rear Hub Assembly With Bearing As Needed. Test drove and noise has been repaired.
Debra C. gave our service a 5 star review on 12/5/2023
Verified Irregular Blower Motor Speeds. When Technician Disconnected Blower Resistor And Re-connected Operation Returned To Normal. Poor Connection Likely Cause. No Need To Replace Any Parts At This Time.
Ashley L. gave our service a 5 star review on 11/19/2023
Machine shop tested and trued head= checked good. Performed cylinder head gasket job as needed. Test drove numerous times to verify repair. Vehicle operation is normal at this time.
CYLINDER HEAD GASKET – Remove & Replace – Both – [Includes: Remove carbon and check surfaces for warpage. Includes adjust Valves (where applicable) and clean and adjust Spark Plugs.]
Evacuate and recharge A/C system
Machine /True Cylinder Heads, Test For Leaks/Cracks=Passed INV#79615
RADIATOR – Remove & Replace – Automatic Trans
Change Engine Oil, Filter, Top Fluids Off, Perform 18 Point Inspection And Set Tire Pressure, Reset Maint Light As Needed.
Evacuate and recharge AC
Allison B. gave our service a 5 star review on 11/18/2023